Address Translation-2 MCQ’s

Computer Architecture Electronics & Communication Engineering

This set of Computer Architecture Multiple Choice Questions & Answers (MCQs) focuses on “Address Translation-2″.

1. The _______ bit is used to indicate the validity of the page.
a) Valid bit
b) Invalid bit
c) Correct bit
d) None of the mentioned

2. The bit used to store whether the page has been modified or not is called as _______
a) Dirty bit
b) Modify bit
c) Relocation bit
d) None of the mentioned

3. The bits used to indicate the status of the page in the memory is called ______
a) Control bits
b) Status bits
c) Progress bit
d) None of the mentioned

4. The page table should be ideally situated within ____________
a) Processor
b) TLB
c) MMU
d) Cache

5. When the page table is placed in the main memory, the ___________ is used to store the recently accessed pages.
a) MMU
b) TLB
c) R0
d) Table

6. Whenever a request to the page that is not present in the main memory is accessed ______ is triggered.
a) Interrupt
b) Request
c) Page fault
d) None of the mentioned

7. If the page table is large then it is stored in __________
a) Processor
b) Main memory
c) Disk
d) Secondary storage

8. The TLB is incorporated as part of the _________
a) Processor
b) MMU
c) Disk
d) RAM

9. The general purpose registers are combined into a block called as ______
a) Register bank
b) Register Case
c) Register file
d) None of the mentioned

10. What does the RUN signal do?
a) It causes the termination of a signal
b) It causes a particular signal to perform its operation
c) It causes a particular signal to end
d) It increments the step counter by one

Leave a Reply

Your email address will not be published. Required fields are marked *